v1.14.0 Granular Pump Control

[AndreWohnsland]

This release gives you more power and options to configure your pump or the controller board. You can now reduce the number of active running pumps, if you went overboard with 16 high draining pumps, and also use other switching circuits than the inverted relay arrays. If you want, you can delete your local database and set up your own. Also, new update notification will show the release notes, to inform what the update will do.

🆕 New Features of this Release

• Added a cocktail icon beside prepare button
• Better space management in the recipe section
• MAKER_SIMULTANEOUSLY_PUMPS: control the maximum number of active simultaneously running pumps
• MAKER_PINS_INVERTED: switch the pin (low/high) signal on (off/on) state, default behavior (True) stays the same
• New custom prompt (yes / no) window
• With the update notification, up to 5 notes of not installed updates will be shown
• Added CLI command to clear local database for own setup / entry
• Added documentation for all new things
• Console logs for preparation are more consistent over the different options
• Increased alcohol step size

🔧 Dev Notes

• The interface for the pin controller uses now the inverted argument

🐛 Bug Fixes

• Fixed a bug which prevented cocktail preparation after running the calibration UI
• Fixed a bug which could cause the border radius in some elements to disappear

---

This discussion was created from the release v1.14.0 Granular Pump Control.