ADRV9009 Platform Quick Start Guide

Table of Contents

Follow the steps in the order shown below.

1. Introduction
2. Prepare and Install the SD Card
3. Install Required Hardware
4. Install Required Software
5. Run the Demonstration

Introduction

This Quick Start Guide describes the hardware and software setup needed to run the Example Design.

In addition this Guide instructs the user how to use the example design to verify interoperability between the FPGA and the ADRV9009. This is done by using the IIO Oscilloscope application to generate outbound DAC waveforms that are looped back to the ADC and displayed in time or frequency domains.

Next- Prepare and Install the SD Card

Return to ADRV9009® Platform User Guide