+
+ +
+

iWave G35P

+
    +
  • +
    Card information:
      +

    • Vendor: iWave

      • +

    • Name: G35P

      • +
    • +
      Ethernet ports: 3x QSFP-DD
        +

      • 2x 200G

        • +

      • 1x 40G

        • +
      +
      +
      +
      • +

    • PCIe conectors: Edge connector

      • +

    • FPGA Card Website

      • +
    +
    +
    +
    • +
  • +
    FPGA specification:
      +

    • FPGA part number: xczu19eg-ffvc1760-2-i

      • +

    • Ethernet Hard IP: CMAC (up to 100G Ethernet)

      • +

    • PCIe Hard IP: USP (up to PCIe Gen3 x16)

      • +
    +
    +
    +
    • +
+
+

NDK firmware support

+
    +
  • +
    Ethernet cores that are supported in the NDK firmware:
    +
    +
    +
    • +
  • +
    PCIe cores that are supported in the NDK firmware:
      +

    • USP in the PCIe Module

      • +

    • See the <NDK-FPGA_root_directory>/card/iwave/g35p/config/card_conf.tcl file for supported PCIe configurations.

      • +
    +
    +
    +
    • +
  • +
    Makefile targets for building the NDK firmware (valid for Minimal app, may vary for other apps):
      +

    • Use make 100g2 command for firmware with 2x100GbE (default).

      • +
    +
    +
    +
    • +
  • +
    Support for booting the NDK firmware using the nfb-boot tool:
      +

    • NO.

      • +
    +
    +
    +
    • +
+
+
+

Boot instructions

+
    +
  • +
    Set Switch 1 (SW1(3:0)) to SD1 mode:
      +

    • SW1(0) - ON

      • +

    • SW1(1) - OFF

      • +

    • SW1(2) - ON

      • +

    • SW1(3) - OFF

      • +
    +
    +
    +
    • +

  • Note that default setting is set to SW1: OFF ON ON OFF

    • +

  • Note that SW1 is present on the SOM module (under the heatsink)

    • +
  • +
    Write the BOOT.bin file to the SD card:
      +

    • BOOT.bin can be generated by AMD VitisTM <https://www.amd.com/en/products/software/adaptive-socs-and-fpgas/vitis.html>

      • +
    • +
      In order to generate BOOT.bin, it is necessary to have the fsbl.elf file (first stage boot loader) and the generated bit stream.
        +

      • [bootloader] zynqmp_fsbl.elf

        • +

      • [destination_device = pl] fpga.bit

        • +
      +
      +
      +
      • +
    +
    +
    +
    • +

  • Insert the SD card into the SD connector at the bottom of the FPGA card.

    • +
+
+

Note

+

To build the NDK firmware for this card, you must have the Xilinx Vivado installed, including a valid license.

+
+
+
+ + +
+