major failsafe issue found in tandem receivers

[cje0114]

I believe I might have found a major bug in tandem receivers.…I can replicate the issue every time with tdr12, stabilized tdr12, and a tdr10.…all of my regular accst and access 2.4 rx’s are fine.

Here’s what’s going on:

I set the failsafe setting to custom and set all my channels. I test by leaving the rx on and powering off my x20s tx. Failsafe works as it should. I can power on the tx and test again and it still works as it should. Power down the tx and rx, power on, test again and the surfaces hold position and won’t go to where I have them set to in the custom settings.

If I go to the failsafe settings and exit out again the failsafe works as it should until the power to the rx is turned off and back on again.

I’ve tried different firmware on the rx’s and the internal module in my tx with the same result every time.

This could be a major problem and I ask that other people check their failsafe and report back.

Hopefully a fix can be had quickly for this.