🌟T-Display-S3-Long🌟

1️⃣Product

Product(PinMap)	SOC	Flash	PSRAM	Resolution
T-Display-S3-Long	ESP32-S3R8	16MB	8MB(OPI)	180x640

2️⃣Examples

examples/
├── Factory                 # Factory example
├── tft                     # Tft example
├── touch                   # Touchpad example
└── lvgl_demo               # LVGL examples  

3️⃣ PlatformIO Quick Start (Recommended)

1. Install Visual Studio Code and Python
2. Search for the PlatformIO plugin in the VisualStudioCode extension and install it.
3. After the installation is complete, you need to restart VisualStudioCode
4. After restarting VisualStudioCode, select File in the upper left corner of VisualStudioCode -> Open Folder -> select the T-Display-S3-Long directory
5. Wait for the installation of third-party dependent libraries to complete
6. Click on the platformio.ini file, and in the platformio column
7. Uncomment one of the lines src_dir = xxxx to make sure only one line works
8. Click the (✔) symbol in the lower left corner to compile
9. Connect the board to the computer USB
10. Click (→) to upload firmware
11. Click (plug symbol) to monitor serial output
12. If it cannot be written, or the USB device keeps flashing, please check the FAQ below

4️⃣ Arduino IDE Quick Start

• It is recommended to use platformio without cumbersome steps

1. Install Arduino IDE
2. Download or clone project T-Display-S3-Long
3. Copy all the files in T-Display-S3-Long/lib and paste them into Arduion library folder(e.g. C:\Users\YourName\Documents\Arduino\libraries).
4. Open Arduino IDE, select the examples\xxx example of project T-Display-S3-Long throught "File->Open".
5. Configuration of board is as follows:

6. Select Port
7. Click upload , Wait for compilation and writing to complete
8. If it cannot be written, or the USB device keeps flashing, please check the FAQ below

5️⃣ ESP32 basic examples

• BLE Examples
• WiFi Examples
• SPIFFS Examples
• FFat Examples
• For more examples of esp32 chip functions, please refer to arduino-esp32-libraries

6️⃣ FAQ

1. The board uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.

   1. Connect the board via the USB cable
   2. Press and hold the BOOT button , While still pressing the BOOT button, press RST
   3. Release the RST
   4. Release the BOOT button
   5. Upload sketch

2. If the above is invalid, burn the binary file to check whether the hardware is normal

7️⃣ Depends on required libraries

Do not upgrade the LVGL version, the lvgl software rotation has been forced to open.

• lvgl 8.3.0
• XPowersLib