Cannot finish the compass calibration #10
Answered
by
HefnySco
thiensu1122
asked this question in
Q&A
-
|
Hi HefnySco, This is another problem that I found. In the Mission Planner -> compass calibration. I just cannot finish the calibration after it reaches 100%. it just restarts itself from 0% over and over again.
Do you know how to deal with this? |
Beta Was this translation helpful? Give feedback.
Answered by
HefnySco
Apr 14, 2022
Replies: 1 comment
-
|
I usually use QGC as I use Linux. but It should not matter. Make sure that there is no magnetic field around your board while calibration, and rotate it all sides. This is how I do it and it works. |
Beta Was this translation helpful? Give feedback.
0 replies
Answer selected by
thiensu1122
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I usually use QGC as I use Linux. but It should not matter. Make sure that there is no magnetic field around your board while calibration, and rotate it all sides. This is how I do it and it works.