UBL only probes 57 of 100 points? #240
-
|
I have adjusted my x,y,z offsets and run ABL it probes 57 of 100 points then stops and prompts me to save. It does the same if I do it from the machine screen or if I do it through OctoPrint. My mesh shows up and I'm getting good prints but I'm stuck thinking I'm doing something wrong? Specs: |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
The same happens to me when i am complete I am at 157/225 |
Beta Was this translation helpful? Give feedback.
-
|
Same here, can't understand why... Edits: Seems normal after all. It displays all the point in the mesh and only probe the accessible ones. |
Beta Was this translation helpful? Give feedback.
-
|
We already had that discussion: the probe can not reach all 100 points and therefore only probes the one it can reach. The other points can be extrapolated with |
Beta Was this translation helpful? Give feedback.
-
|
As a note: The firmware handles all required extrapolation for you using G29 P3 commands |
Beta Was this translation helpful? Give feedback.
We already had that discussion: the probe can not reach all 100 points and therefore only probes the one it can reach. The other points can be extrapolated with
G29 P3I believe...