Suggestion: Add Jerk and Acceleration settings to bridge settings.

[SquirrelEngineering]

[3.6] Cura
Windows 10
Monoprice maker select
Bridging PETG
Edges are sagging and stretching out. Not sticking at the edges

I was hoping I could adjust the jerk and accel to play with the time the nozzle spends reversing its direction.

Keep up the good work!

Thanks.

[Julius971]

Id like to have such s feature as well. I am having issues with bridging caused by acceleration and deceleration. The printer wont utilize the low printing speed set by the experimental bridging setting, due to acceleration values.
I am missing a feature to slow down the printhead to reach the briding speed as soon as the bridge starts.

[smartavionics]

My Cura variant which you can find at https://github.com/smartavionics/Cura/releases provides settings to control acceleration and jerk for bridge walls and skins.

[GregValiant]

@SquirrelEngineering I'm cleaning house around here. It's been nearly 7 hears and this has not been picked up. Can I go ahead and close this?

[SquirrelEngineering]

I would say so

…

On Sun, Nov 24, 2024, 4:58 PM GregValiant ***@***.***> wrote: @SquirrelEngineering <https://github.com/SquirrelEngineering> I'm cleaning house around here. It's been nearly 7 hears and this has not been picked up. Can I go ahead and close this? — Reply to this email directly, view it on GitHub <#4955 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AIMLERGKWLWF7F65EOHQVJD2CJK2BAVCNFSM6AAAAABSMXFXL6VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDIOJWGMYDIOJUGA> . You are receiving this because you were mentioned.Message ID: ***@***.***>

[GregValiant]

Thanks.