You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi
i am trying to set up marlin on Octopus 1.1 with TMC2209 motor drivers over uart
and for some reason motors seems like does not receive power
Extruder driver even not responds:
M122 : Driver registers: X 0xC0:0C:00:00 Y 0xC0:0C:00:00 Z 0xC0:0C:00:00 E 0x00:00:00:00 Bad response! Testing X connection... OK Testing Y connection... OK Testing Z connection... OK Testing E connection... Error: All LOW
I turned off input shaping in hope that this causes problem but no success
i have board connected also to external power (not only USB)
I changed order of drivers but extruder still did not respond
For now i have only connected endstops and motors
Endstops when not connected and not pressed has state open
Maybye my board is just faulty? Or i messed up config?
Hi
i am trying to set up marlin on Octopus 1.1 with TMC2209 motor drivers over uart
and for some reason motors seems like does not receive power
Extruder driver even not responds:
M122 :
Driver registers: X 0xC0:0C:00:00 Y 0xC0:0C:00:00 Z 0xC0:0C:00:00 E 0x00:00:00:00 Bad response! Testing X connection... OK Testing Y connection... OK Testing Z connection... OK Testing E connection... Error: All LOW
I turned off input shaping in hope that this causes problem but no success
i have board connected also to external power (not only USB)
I changed order of drivers but extruder still did not respond
For now i have only connected endstops and motors
Endstops when not connected and not pressed has state open
Maybye my board is just faulty? Or i messed up config?
Those are my config files (i changed extension from .h to .txt):
Configuration_adv.txt
Configuration.txt
Thank you in advance
The text was updated successfully, but these errors were encountered: