Home Assistant Installation Guide
This page describes the installaton of the Bosch integration.
You Home Assistant should have a HACS installed and fully working. Please follow the guide at HACS for guidance. Manual installation of the integration is possible, but not covered on this page.
The integration is using HTTP and XMPP to connect to the Bosch gateway. Please ensure that your network has no blocking firewall for XMPP traffic. XMPP uses under normal circumstances port 5222 and or 5223.
Connection to a CT200 EasyControl requires a password. This needs to be set at the EasyControl App. See details below
- Go to Settings:
- Go to Personal
- Next screen has option to Change your thermostat password.
To setup component go to Integration page in Home Assistant, click + to add integration and choose
Bosch thermostat.
Choose your device type. For:
- CT200 - EasyControl,
- NEFIT - NEFIT
- KM200, RC300 etc. - IVT
Choose protocol for IVT - either XMPP or HTTP (HTTP is local). For rest of devices it's only possible to use XMPP. Then screen will appear with following inputs:
- SERIAL Number / IP Address
- Access token
- Password
Now you have to find sticker on your KM device (sample sticker below) and put info as follows:
- IP Address -> ip address of your device
- Access token -> password from sticker without dashes (-)
- Password -> password you set in application My Mode or similar. For EasyControl look note below. #password-in-easycontrol-type-app-ct200
If you want put devices in areas. Wait for about 5 seconds and choose area for gateway. More devices should come up on the screen. Choose areas you want. Click submit.
Go to sensors section in Wiki to configure sensors.