caMicroscope
Ready to Start Executing Tasks After Initial Setup - Seeking Guidance #729
-
|
Hello @birm , I am Ayush Tiwari, and I have recently completed the initial setup for contributing to the caMicroscope project. I followed all the steps, including cloning the necessary repositories, installing Docker, and successfully running the caMicroscope application locally. Could you please advise if I should start with the mentioned tasks or if there are any preliminary steps I should consider? Thank you in advance for your guidance and support! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 3 replies
-
|
Hi @birm . I am facing difficulty in getting the changes reflected on the localhost:4010 on my machine. I tried to make some changes on the landing page but can't get them reflected in the running application. Can you please help? |
Beta Was this translation helpful? Give feedback.
-
|
Can you tell me a bit about how you set up your project to reflect changes? The two ways I've typically done development are either mounting your caMicroscope cloned dir in Distro (see https://github.com/camicroscope/camicroscope?tab=readme-ov-file#fast-local-changes), or by pushing to a fork used within 'ca-back''s container. (first configure fork and branch under back, then after rebuilding back, you can run docker exec -it ca-back bash, then pull) |
Beta Was this translation helpful? Give feedback.
-
|
@birm , thank you very much, this was what I tried to explain on the other channel, you have clarified my ambiguity. "The two ways I've typically done development are either mounting your caMicroscope cloned dir in Distro (see https://github.com/camicroscope/camicroscope?tab=readme-ov-file#fast-local-changes), or by pushing to a fork used within 'ca-back''s container. (first configure fork and branch under back, then after rebuilding back, you can run docker exec -it ca-back bash, then pull)" |
Beta Was this translation helpful? Give feedback.
-
|
I created one directory and in that I have cloned the repositories. |
Beta Was this translation helpful? Give feedback.
Can you tell me a bit about how you set up your project to reflect changes?
The two ways I've typically done development are either mounting your caMicroscope cloned dir in Distro (see https://github.com/camicroscope/camicroscope?tab=readme-ov-file#fast-local-changes), or by pushing to a fork used within 'ca-back''s container. (first configure fork and branch under back, then after rebuilding back, you can run docker exec -it ca-back bash, then pull)