Skip to content

Latest commit

 

History

History
43 lines (35 loc) · 6.33 KB

board_waveshare.md

File metadata and controls

43 lines (35 loc) · 6.33 KB

Waveshare

Supported Development Boards

Picture Name LCD Bus LCD Controller LCD resolution Touch Bus Touch Controller
ESP32-S3-Touch-LCD-1.85 QSPI ST77916 360x360 I2C CST816
ESP32-S3-Touch-LCD-2.1 RGB ST7701 480x480 I2C CST820 (CST816-like)
ESP32-S3-Touch-LCD-4.3 RGB ST7262 800x480 I2C GT911
ESP32-S3-Touch-LCD-4.3B RGB ST7262 800x480 I2C GT911
ESP32-S3-Touch-LCD-5 RGB ST7262 800x480 I2C GT911
ESP32-S3-Touch-LCD-5B RGB ST7262 1024x600 I2C GT911
ESP32-S3-Touch-LCD-7 RGB ST7262 800x480 I2C GT911
ESP32-P4-NANO MIPI-DSI JD9365 800x1280 I2C GT9271 (GT911-like)

Recommended Configurations

Below are recommended configurations for developing GUI applications on different development boards.

Arduino IDE

These settings can be adjusted according to specific requirements, and users can navigate to the Tools menu in the Arduino IDE to configure the following settings.

Supported Boards Selected Board PSRAM Flash Mode Flash Size USB CDC On Boot Partition Scheme
Waveshare-ESP32-S3-Touch-LCD-1.85 ESP32S3 Dev Module OPI QIO 80MHz 16MB Enabled 16M Flash (3MB)
Waveshare-ESP32-S3-Touch-LCD-2.1 ESP32S3 Dev Module OPI QIO 80MHz 16MB Enabled 16M Flash (3MB)
Waveshare-ESP32-S3-Touch-LCD-4.3 ESP32S3 Dev Module OPI QIO 80MHz 8MB Disabled 8M with spiffs
Waveshare-ESP32-S3-Touch-LCD-4.3B ESP32S3 Dev Module OPI QIO 80MHz 16MB Enabled 16M Flash (3MB)
Waveshare-ESP32-S3-Touch-LCD-5 ESP32S3 Dev Module OPI QIO 80MHz 16MB Enabled 16M Flash (3MB)
Waveshare-ESP32-S3-Touch-LCD-5B ESP32S3 Dev Module OPI QIO 80MHz 16MB Enabled 16M Flash (3MB)
Waveshare-ESP32-S3-Touch-LCD-7 ESP32S3 Dev Module OPI QIO 80MHz 8MB Disabled 8M with spiffs
Waveshare-ESP32-P4-NANO ESP32P4 Dev Module Enabled QIO 16MB Disabled 16M Flash (3MB)

Note

  1. Enable or disable USB CDC On Boot based on the type of port used:

    • Disable this configuration if using UART port; enable it if using USB port.
    • If this configuration differs from previous flashing, first enable Erase All Flash Before Sketch Upload, then it can be disabled after flashing.
    • If this configuration does not match the actual port type, it will prevent the development board from printing serial logs correctly.

  2. To view more output logs, set Core Debug Level to Info or a lower level.

  3. If the predefined partition schemes provided by ESP32 do not meet the requirements, users can also select Custom in the "Partition Scheme" and create a custom partition table file Custom.csv in the hardware/esp32/3.x.x/tools/partitions directory under the arduino-esp32 installation directory. For detailed information on partition tables, please refer to the ESP-IDF documentation.