HydraFW OpenOCD guide

OpenOCD mode

This guide is updated towards development firmware

OpenOCD can be used with the same protocol as the bus pirate.

• It is recommended to use OpenOCD v0.10 or more (see http://openocd.org)
• HydraBus HydraFW natively support OpenOCD BusPirate JTAG or SWD mode using BBIO_JTAG for JTAG and BBIO_RAWWIRE for SWD
  • For more details on HydraFW BBIO_JTAG see following links:
    • https://github.com/hydrabus/hydrafw/blob/master/src/hydrabus/hydrabus_bbio.c see "case BBIO_JTAG:" in code
    • https://github.com/hydrabus/hydrafw/blob/master/src/hydrabus/hydrabus_mode_jtag.c see jtag_enter_openocd()
  • For more details on HydraFW BBIO_RAWWIRE see https://github.com/hydrabus/hydrafw/blob/master/src/hydrabus/hydrabus_bbio_rawwire.c
  • For more details on how it is supported in OpenOCD see https://repo.or.cz/openocd.git/blob/HEAD:/src/jtag/drivers/buspirate.c

JTAG

Example OpenOCD configuration :

source [find interface/buspirate.cfg]

buspirate_mode open-drain
buspirate_pullup 1

buspirate_port /dev/ttyACM0

transport select jtag

If you know the target JTAG pins, connect them on the default pins and run OpenOCD with your configuration file.

Combining JTAG pin discovery and OpenOCD mode

It is possible to discover the JTAG pins and use them without changing the wiring :

• Use the brute commands to discover the pins.
• Once the pins are discovered, validate them using bypass and idcode commands.
• Run the openocd command
• Leave the Hydrabus terminal
• Run OpenOCD with your configuration file

SWD

Hydrabus can also be used as an SWD interface to connect to various devices.

Hydrabus PIN	SWD Signal
PB3	SWDCLK
PB4	SWDIO
PC4	nRST

An example configuration can be found in utils/openocd/hydrabus_swd_host.cfg

Debugging Hydrabus with an external debugger

Hydrabus can be debugged using an external SWD interface on the debug pins using the OpenOCD configuration found in utils/openocd/hydrabus_target.cfg

Additional informations about OpenOCD mode

See tutorial here :

• https://cybermashup.com/2014/05/01/jtag-debugging-made-easy-with-bus-pirate-and-openocd/
• "JTAG mode using openOCD" https://ark444.github.io/posts/HydraBus_presentation