-
Notifications
You must be signed in to change notification settings - Fork 92
HydraFW binary MMC mode guide
This guide is updated towards firmware release HydraFW v0.11 and later
This mode is specific to MMC/eMMC (and it does not support SDCard).
- For SDCard support, see SDIO
This mode allows to control MMC
- MMC pins: CLK=PC12, CMD=PD2, D0=PC8
For more details see https://github.com/hydrabus/hydrafw/wiki/HydraFW-MMC-guide
Once the MMC mode has been selected, the following commands are available :
-
0b00000000
Return to main mode. Returns BBIO1 -
0b00000001
Mode identification. ReturnsMMC1
-
0b00000010
Read CID -
0b00000011
Read CSD -
0b00000100
Read block -
0b00000101
Write block -
0b00000110
Read EXT_CSD -
0b1000000x
Configure MMC interface
This command will reply with 16 bytes containing the card CID.
This command will reply with 16 bytes containing the card CSD.
This command will read the next 4 bytes as the block number (little-endian). The command will reply 0x01
followed by the resulting block data (512 bytes). It will reply 0x00
in case of error.
This command will read the next 4 bytes as the block number (little-endian), then 512 bytes of data. The command will reply 0x01
if successful, 0x00
otherwise.
The command will reply 0x01
followed by 512 bytes of EXT_CSD register value if successful, 0x00
otherwise.
The x
value is used to set the MMC bus width :
-
0
is 1-bit mode -
1
is 4-bit mode
- CHANGELOG
- Console commands
- Binary mode guide
-
NFC/HydraNFC v1 guide
- Read UID of an ISO/IEC_14443 Tag
- Read UID and data of a MIFARE Ultralight Tag
- Read UID of an ISO/IEC 15693 Tag
- Emul ISO14443a Tag
- Emul MIFARE Ultralight Tag
- Emul Mifare Classic Tag
- Unique NFC sniffer design
- Launch NFC sniffer from console
- Sniffer ISO14443A wireshark pcap
- Autonomous/stand-alone sniffer mode
- Sniffer ISO14443A real-time infinite trace mode
- HydraFW-HydraNFC-v1.x-TRF7970A-Tutorial