Onboard 1Gig Ethernet Port Not Working

[wadetm]

I'm not able to get the LibreSDR to grab a DHCP IP when I plugin a ethernet cable into my network, is there a setting I need to change to enable the ethernet jack?

BTW, I can access the LibreSDR over USB by setting a static IP on the Pluto Virtual Ethernet adapter, but it seems slow and I'm not able to get much use out of my intended use case with DATV-Express when using more than 2M BW channels for DVB-T.

[wadetm]

I took board out of the aluminum enclosure and found that the ethernet transceiver being used is a RealTek RTL8211E, does the firmware have drivers for this chip?

[lucasmellon-ops]

Here's the workaround I used plug-in both USB C ports, wait. In your device manager You'll find the Pluto SDR serial console. Login username root, password analog. Type ifconfig USB0 down. Set a static address. Ignore what your router says, but in your software such as SDR sharp just type in the IP address you configured. I was pulling out my hair because my router would not recognize it being there but it's working.