1.10.14 Aqara Smartplugs, Rollershade und Tint LEuchten nicht mehr ansprechbar

[vaaarg]

describe the problem in Detail. What do you expect to happen ? What does happen ?

Just wanted to leave a note that directly after updating to newest stable version some vendors stopped to work. i directly changed down to last version, with which everything works as intended. The devices were even not deletable, I did not investigate further.

Adapter version

1.10.14

Coordinator firmware version

0000000

Coordinator

type:zStack30x version:2-2.2.7.2. revision:20211222 port:/dev/serial/by-id/usb-Texas_Instruments_CC2538_USB_CDC-if00 channel:11

Setup

pi5

Protocol of the error (as text, encapsulated in multiline code tags <>). Separate different occurrances into clearly split log sections

No response

[asgothian]

This is a known issue (#2351).

Current state is that there are 2 options to move forward:

• deleting the stored network setup (shepherd.db / nvbackup.json) and having to pair all devices anew
• moving to a newer TI based coordinator which can 'inherit' the existing network

There is an open issue on the zigbee-herdsman level to add an option which retains both network and hardware, but that is slow going.

A.

[vaaarg]

This is a known issue (#2351).

Current state is that there are 2 options to move forward:

• deleting the stored network setup (shepherd.db / nvbackup.json) and having to pair all devices anew
• moving to a newer TI based coordinator which can 'inherit' the existing network

There is an open issue on the zigbee-herdsman level to add an option which retains both network and hardware, but that is slow going.

A.

I bought `SLZB-07P7 Zigbee USB CC2652P7' should this do the Job ("inherit the Network") ?

[asgothian]

Yes, that one should work.

[vaaarg]

Yes, that one should work.

great, could you give me a link for proper way to change the coordinator without having to pair everything again.

Probably just plugging out my CC2538 (Arteck Platine) and plugin'in SLZB-07P7 Zigbee USB CC2652P7 wont do it right ? ;)

[asgothian]

Actually, it almost will:

• stop the adapter
• optionally: copy the shepherd.db and nvbackup.json files away for safe keeping
• unplug the cc2531
• plug in the slzb
• open the adapter configuration
• set the correct port for the stick
• start the adapter. Everything should work fine then

[vaaarg]

Works ! Top thank You.

[vaaarg]

Best Usecase for the remaining old flagship ? Router ? 😄

[vaaarg]

i just found Routerfirmware

and flashed it (before i erased the chip) with j-link (TI CC2538SF53TI) and the actual router firmware from above. Segger says successfull flash but the device isnt recognized as router within zigbee.

Did i miss sth ?