For the AB/SB Mount assembly you need the following parts
- 3x 6 mm x 3 mm magnets
- 2 x 18cm 22AWG cable to connect the Klicky Probe to the Microfit Terminal (if it turn out it's too big, can always cut to lenght)
- Multimeter to check for Continuity
- Super Glue
The probe mount wires are also connected with pressure from the magnets, you can use the probe magnets as a template to insert the probe mount magnets, it is easier that way, so that the magnets are not inserted the wrong way.
 |
 |
 |
 |
 |
|---|
You will not lose Y travel on any configuration in the tests that were done.
After everything is assembled let's check again for continuity.
You can now press fit the magnets in place:
Insert the AB mount and probe in the helper parts and you can then press fit with a vice or on a hard surface.
