This block is integrated from the CHERIoT Safe repository. It controls the hardware revoker inside CHERIoT Ibex which is the thing that does the revocation, it is looking for capabilities to freed memory. When a piece of memory is freed its revocation bits are set. The hardware revoker sweeps from the start until the end address for capabilities that point to any revoked region. For more information on how this works please refer to Section 3.3.3 (background pipelined revoker) of this paper.
These are the register offsets:
| Offset | Register |
|---|---|
| 0x0000 | Start address to begin sweeping. |
| 0x0004 | End address to stop sweeping. |
| 0x0008 | Writing any value to this register sets the hardware revoker to run. When read, the most significant byte is set to constant 0x55. |
| 0x000C | Epoch, where the last bit means a sweep is currently happening. |
| 0x0010 | Used to read interrupt status and clear it. |
| 0x0014 | Enable bit for raising an interrupt when sweeping is done. |