[Bug]: Settings not saving for tab coloring

[richiepleaserich]

✈ Pre-Flight checks

• I don't have SentinelOne antivirus installed (see above for the solution)
• I have searched in the issues (open and closed) but couldn't find a similar issue
• I have searched in the pyRevit Forum for similar issues
• I already followed the installation troubleshooting guide thoroughly
• I am using the latest pyRevit Version

🐞 Describe the bug

Hello all. I an running revit 2025 and have pyrevit 5 installed. both are a fresh install as i updated my computer. when i enable the tab coloring setting under the pyevit settings and reload, the settings are not saved and not enabled. if i enable tab coloring and just save settings, it'll save it until revit is closed and relaunched which then its disabled again. i noticed a post on the fourm about a pyRevit_config.ini file that should be under appdata, but it does not exist there but is under program data. i tried this on a PC with revit 2023 installed and it looks to be the same issue.

⌨ Error/Debug Message

N/A

♻️ To Reproduce

1. go pvRevit settings.
2. under UI/UX
3. check colorize open documents
4. project tab and family are both set to background fill.
5. select save settings and reload.

⏲️ Expected behavior

Upon reload, open tabs should be colorized.

🖥️ Hardware and Software Setup (please complete the following information)

Tested on multiple different hardware with same issues

Additional context

No response