EEPROM::update returns EEPROM_OK on success, not FLASH_COMPLETE as stated in comment

[me21]

Arduino_STM32/STM32F1/libraries/EEPROM/EEPROM.cpp

Lines 524 to 544 in 683e5a3

	/**
	* @brief Writes/upadtes variable data in EEPROM.
	The value is written only if differs from the one already saved at the same address.
	* @param VirtAddress: Variable virtual address
	* @param Data: 16 bit data to be written
	* @retval Success or error status:
	* - EEPROM_SAME_VALUE: If new Data matches existing EEPROM Data
	* - FLASH_COMPLETE: on success
	* - EEPROM_BAD_ADDRESS: if address = 0xFFFF
	* - EEPROM_PAGE_FULL: if valid page is full
	* - EEPROM_NO_VALID_PAGE: if no valid page was found
	* - EEPROM_OUT_SIZE: if no empty EEPROM variables
	* - Flash error code: on write Flash error
	*/
	uint16 EEPROMClass::update(uint16 Address, uint16 Data)
	{
	if (read(Address) == Data)
	return EEPROM_SAME_VALUE;
	else
	return write(Address, Data);
	}

The comment needs to be updated.

The same applies to EEPROM::write and EEPROM::EE_VerifyPageFullWriteVariable.