#MultiRAT-Handover

##Introduction

This program is for efficient handover of dual WLAN device. It uses each WLAN as active link and standby link. Active link is used for communicating and standby link is used for scanning APs. Program make link overlapped on previous link of active link when handover needed.

####This program is comprise of follow codes

main.c 					//Take charge of whole phase of program
handover_manager.c		//Algorithm specific functions
wireless_manager.c		//Control wireless interfaces

getXYZ.py				//Get accelerometer sensor value
adxl345.pyc				//for getXYZ.py

makefile

##How to execute program

1. Install open vswitch apt-get install openvswitch-switch openvswitch-brcompat openvswitch-datapath-source libiw-dev

2. Configure local network

   • Open NetConfigure.sh
   • Modify MAC Address table and IP address of br0
   • ./NetConfigure.sh

3. Make execution file make

4. Start handover program sudo ./test