chore(motion_velocity_smoother): add enable curve filtering param (#580)

Signed-off-by: Takamasa Horibe <[email protected]>

autoware_launch/config/planning/scenario_planning/common/motion_velocity_smoother/motion_velocity_smoother.param.yaml

@@ -11,12 +11,14 @@
     # common parameters
     curvature_calculation_distance: 5.0         # distance of points while curvature is calculating for the steer rate and lateral acceleration limit [m]
     # lateral acceleration limit parameters
+    enable_lateral_acc_limit: true     # To toggle the lateral acc filter on and off. You can switch it dynamically at runtime.
     max_lateral_accel: 1.0             # max lateral acceleration limit [m/ss]
     min_curve_velocity: 2.74            # min velocity at lateral acceleration limit and steering angle rate limit [m/s]
     decel_distance_before_curve: 3.5   # slow speed distance before a curve for lateral acceleration limit
     decel_distance_after_curve: 2.0    # slow speed distance after a curve for lateral acceleration limit
     min_decel_for_lateral_acc_lim_filter: -2.5  # deceleration limit applied in the lateral acceleration filter to avoid sudden braking [m/ss]
     # steering angle rate limit parameters
+    enable_steering_rate_limit: true         # To toggle the steer rate filter on and off. You can switch it dynamically at runtime.
     max_steering_angle_rate: 40.0            # maximum steering angle rate [degree/s]
     resample_ds: 0.1                         # distance between trajectory points [m]
     curvature_threshold: 0.02                # if curvature > curvature_threshold, steeringRateLimit is triggered [1/m]
@@ -55,8 +57,6 @@
     post_sparse_resample_dt: 0.1             # resample time interval for sparse sampling [s]
     post_sparse_min_interval_distance: 1.0   # minimum points-interval length for sparse sampling [m]
 
-
-
     # system
     over_stop_velocity_warn_thr: 1.389       # used to check if the optimization exceeds the input velocity on the stop point