Z-Butt OpenSCAD

An exploratory port of Zappycobra's Z-Butt system to OpenSCAD.

Notes

• To reduce the repository size, only STLs for 1u and 2u keycaps have been included. The full set can be built from the repository by editing the SIZES variable in Makefile (see “Building” below).
• Measurements can be altered by changing values in the “User Parameters” section of the z-butt.scad library.
• Of particular note is the sprue_max_distance parameter, which can be used to make sprue placement denser or sparser.
• MX stems for stabilizers have been included on larger spacebars, though these are tentative and it is advised to check them before printing.

Images

Maker's Mark

A Maker's Mark can be added by creating a 2-D polygon in makers-mark.scad. See the file for an example.

Building

For building on Linux, OpenSCAD and GNU Make should be installed.

To rebuild the STLs after altering parameters, run:

make

Or to use, for example, four cores in parallel:

make -j 4