udpate readme

README.md

@@ -6,61 +6,4 @@ Defines a package to make it easy and performant to control actuators.
 
 ## Getting Started
 
-### Install Build Dependencies
-
-#### Ubuntu
-
-```bash
-sudo apt install pkg-config libudev-dev
-```
-
-### Install the Package
-
-```bash
-pip install actuator
-```
-
-Alternatively, to install the bleeding edge version from Github:
-
-```bash
-pip install 'actuator @ git+https://github.com/kscalelabs/actuator.git@master'
-```
-
-### Motor-Specific Examples
-
-#### Robstride
-
-The following example can be used to move a Robstride motor in a sinusoidal pattern.
-
-```bash
-python -m actuator.examples.sinusoidal_movement
-```
-
-Note that there are some additional steps needed before the Robstride USB controller will work on Linux:
-
-1. Install [this driver](https://github.com/WCHSoftGroup/ch341ser_linux) for the CH341 USB controller.
-2. This should create a `/dev/ttyUSB0` or `/dev/ttyCH341USB0` device - you should check which one by doing `ls /dev/tty*`.
-You might need to the change the permissions:
-
-```bash
-sudo chmod 666 /dev/ttyCH341USB0
-```
-
-3. Run the following command to configure the baud rate of the controller:
-
-```bash
-sudo stty -F /dev/ttyUSB0 921600
-```
-
-4. Alternatively, you can add the following line to your `/etc/udev/rules.d/51-ch340.rules` file to automatically configure the baud rate:
-```bash
-KERNEL=="ttyCH341USB[0-9]", ATTRS{idVendor}=="1a86", ATTRS{idProduct}=="7523", SYMLINK+="ttyUSB%n", RUN+="/bin/stty -F /dev/ttyCH341USB0 921600"
-KERNEL=="ttyUSB[0-9]", ATTRS{idVendor}=="1a86", ATTRS{idProduct}=="7523", RUN+="/bin/stty -F /dev/ttyUSB0 921600"
-```
-
-5. After adding the above rule, you should run `sudo udevadm control --reload-rules` to reload the rules.
-
-
-## Supported Actuators
-
-- [Robstride](https://robstride.com/)
+See the documentation [here](https://docs.kscale.dev/software/actuators/overview) for instructions on getting started with this package.