两种方式二选一, 推荐 webui 复位, 不成功再尝试 u-boot 擦除分区
- webui 点恢复出厂配置
- 重启进入u-boot console
U-Boot 2020.01 (Jun 07 2024 - 13:38:06 +0800) for emei
DRAM: 256 MiB
WDT: Started with servicing (30s timeout)
NAND: 256 MiB
Loading Environment from NAND... OK
In: uart@0x1010f000
Out: uart@0x1010f000
Err: uart@0x1010f000
Reset Info: Linux reboot cmd to reset
Net: Could not get PHY for eth8: addr 1
gemac@8 no phy device
Warning: pie (eth0) using random MAC address - ca:a4:99:ad:19:1e
eth0: pie
bootflag a bootreg 10
net_loop_init, protocol: 16
multiupg detect
bootdelay is 3000
# 枚举MTD分区
mtd listList of MTD devices:
* nand0
- type: NAND flash
- block size: 0x20000 bytes
- min I/O: 0x800 bytes
- OOB size: 64 bytes
- OOB available: 30 bytes
- 0x000000000000-0x000010000000 : "nand0"
...
- 0x000000180000-0x000000380000 : "fac"
- 0x000000380000-0x000000580000 : "cfga"
- 0x000000580000-0x000000780000 : "cfgb"
...
- 0x000000c80000-0x000001280000 : "kernela"
...
# mtd erase fac # 擦除校准和产测数据
mtd erase cfga # 擦除配置分区a
mtd erase cfgb # 擦除配置分区b
- 重启写入产测数据
- 注意看配置的 注释信息
# 启动 linux 后, 进入telnet/console
# 网口数量写错, 会导致omci等查询业务异常退出, GPON不能被OLT获取 capabilitiy
hi_cfm set board.lan_ports eth0,eth1,eth2,eth3
hi_cfm set board.usb2_num 2
hi_cfm set board.usb3_num 0
hi_cfm set board.voice_num 1
hi_cfm set sysinfo.operator CMCC
# 光猫是 HGU, 路由是 router
hi_cfm set sysinfo.mode HGU
# 光猫必填 gpon, 否则配置无法正常生成
hi_cfm set sysinfo.pon_adapt gpon
# MAC 地址不能冲突, 否则OLT 能够 autofind, 但是无法 confirm;
hi_cfm set sysinfo.gateway_mac cc:aa:ee:bb:00:11
hi_cfm set board.wlan24 4
hi_cfm set board.wlan58 4
hi_cfm set board.lan_ports eth0,eth1,eth2,eth3,vap0,vap1,vap2,vap3,%4,vap8,vap9,vap10,vap11
# OLT上线用于 sn-auth 的序列号, loid, 密码;
hi_cfm set sysinfo.product_sn HWHW78560001
hi_cfm set sysinfo.auid.sn 0x48 0x57 0x48 0x57 0x51 0x17 0x52 0x33
hi_cfm set sysinfo.loid 86868686
hi_cfm set sysinfo.lopwd 12345
hi_cfm config
reboot- webui配置桥模式(业务)
- OLT 配置
ont-srvprofile gpon profile-id 4 profile-name "ftth"
ont-port pots 1 eth 4
port vlan eth 1 translation 101 user-vlan 101
commit
quit
ont-lineprofile gpon profile-id 4 profile-name "ftth"
tcont 1 dba-profile-id 3
gem add 0 eth tcont 1
gem mapping 0 0 vlan 101
gem mapping 0 1 vlan 102
commit
quit
<mcu 0/2>
interface mcu 0/2
<vlan-config>
vlan 101 to 104 smart
port vlan 101 to 104 0/2 0
<interface gpon 0/2>
interface gpon 0/0
port 0 ont-auto-find enable
port pon-id 0 enable
port 1 ont-auto-find enable
ont add 0 1 sn-auth "******" omci ont-lineprofile-id 4 ont-srvprofile-id 4 desc ""
<bbs-config>
service-port 24 vlan 101 gpon 0/0/0 ont 2 gemport 0 multi-service user-vlan 101 tag-transform translate
service-port 25 vlan 102 gpon 0/0/0 ont 2 gemport 0 multi-service user-vlan 102 tag-transform translate
- ONT/ONU在OLT上线
MA5608T(config)#display ont info 0 0 0 1
-----------------------------------------------------------------------------
F/S/P : 0/0/0
ONT-ID : 1
Control flag : active
Run state : online
Config state : normal
Match state : match
DBA type : SR
ONT distance(m) : 17
ONT last distance(m) : 17
ONT battery state : holding state
ONT power type : -
Memory occupation : -
CPU occupation : -
Temperature : -
Authentic type : SN-auth
SN : 4857485751175233 (HWHW-51175233)
Management mode : OMCI
Software work mode : normal
Isolation state : normal
ONT IP 0 address/mask : -
Description : ONT_NO_DESCRIPTION
Last down cause : LOS
Last up time : 2024-06-14 19:23:16+08:00
Last down time : 2024-06-14 19:22:14+08:00
Last dying gasp time : -
ONT online duration : 0 day(s), 0 hour(s), 36 minute(s), 4 second(s)
ONT system up duration : -
Type C support : Not support
Interoperability-mode : ITU-T
Power reduction status : -
FEC upstream state : use-profile-config
-----------------------------------------------------------------------------
VoIP configure method : Default
-----------------------------------------------------------------------------
Line profile ID : 4
Line profile name : ftth
-----------------------------------------------------------------------------
FEC upstream switch :Disable
OMCC encrypt switch :Off
Qos mode :PQ
Mapping mode :VLAN
TR069 management :Disable
TR069 IP index :0
------------------------------------------------------------------------------
Notes: * indicates Discrete TCONT(TCONT Unbound)
------------------------------------------------------------------------------
<T-CONT 0> DBA Profile-ID:1
<T-CONT 1> DBA Profile-ID:3
<Gem Index 0>
--------------------------------------------------------------------
|Serv-Type:ETH |Encrypt:off |Cascade:off |GEM-CAR:- |
|Upstream-priority-queue:0 |Downstream-priority-queue:- |
--------------------------------------------------------------------
Mapping VLAN Priority Port Port Bundle Flow Transparent
index type ID ID CAR
--------------------------------------------------------------------
0 101 - - - - - -
1 102 - - - - - -
2 103 - - - - - -
3 104 - - - - - -
--------------------------------------------------------------------
------------------------------------------------------------------------------
Notes: Run the display traffic table ip command to query
traffic table configuration
-----------------------------------------------------------------------------
Service profile ID : 4
Service profile name : ftth
-----------------------------------------------------------------------------
Port-type Port-number Max-adaptive-number
-----------------------------------------------------------------------------
POTS 1 -
ETH 4 -
VDSL 0 -
TDM 0 -
MOCA 0 -
CATV 0 -
-----------------------------------------------------------------------------
TDM port type : E1
TDM service type : TDMoGem
MAC learning function switch : Enable
ONT transparent function switch : Disable
Ring check switch : Enable
Ring port auto-shutdown : Enable
Ring detect frequency : 8 (pps)
Ring resume interval : 300 (s)
Multicast forward mode : Unconcern
Multicast forward VLAN : -
Multicast mode : Unconcern
Upstream IGMP packet forward mode : Unconcern
Upstream IGMP packet forward VLAN : -
Upstream IGMP packet priority : -
Native VLAN option : Concern
Upstream PQ color policy : -
Downstream PQ color policy : -
Monitor link : Unconcern
MTU(byte) : Unconcern
-----------------------------------------------------------------------------
...
# 例如: 桥模式, GPON 配置了 101 的vlan绑定, 则 OLT 的UPLink对接网口也需要配置101 vlan
ip link add link i219 name i219.101 type vlan id 101