Connect Bang&Olufsen Beogram 5000 turntable with any receiver and remote.
Beogram 5000 use BeoLink protocol to connect with other B&O products(receiver, deck, etc.) using two datalink pins in 7din pinconnector.
Pinout:
- Connect datalink pins to Arduino hardware or software UART. If you are using Software serial, modify serial initialization in setup.
- Connect IR sensor data pin to IR_RECEIVER_PIN(see sketch).
- Connect RECEIVER_INPUT_PIN to receiver "Remote" port on your receiver(usually 3.5mm jack) used for IR remote retranslation.
You'll need to figure out keycodes for your remote controller. Uncomment DEBUG_MODE define in sketch, flash firmware, open terminal - here you can see received keycodes. Replace keycodes defined in nec_code_t enum by your own.